When heat pump is operating in defrost mode ice will thaw from around outdoor coil and water will flow from the unit.
Heat pump defrost board problem.
The next heat pump problem on the list is the heat pump defrost board.
The heat pump condenser operates below the dew point and collecting frost and ice on the heat pump condenser coils.
In the winter heat pump icing up is often perfectly normal.
Use the trane heat pump troubleshooting guides below.
A circuit board in the most common system works off of input and output.
The heat pump should defrost regularly when the frosting occurs and should be long enough to melt all of the ice but short enough to avoid energy waste.
Heat pump troubleshooting problem 1.
Remove fc1 and fc2 fiises from fuseholder.
Of course depending on the issue will depend on where and what you look at with the system.
Check control transformer power 24v.
Verify that fc1 and fc2 fuses on fuse board are not open.
I have an 18 yr old trane heat pump with a 21c140501 defrost control board.
However there s a process in most heat pumps which fixes the iced up problem within the defrost mode.
During the cold winter months your heat pump s outside unit will sometimes be covered with a coating of frost on the sides or even light ice.
If you have problems with your trane heat pump don t rush to call for expensive master s help you can fix your device for free.
Clicking noise heard inside.
Icing up heat pump frozen in winter.
The ice and frost on the heat pump condenser coils need to be removed.
The outside fan will not run.
If power is available to board and led s do not light replace board.
Heat pump problems defrost.
Amazing to have joined the board just in time to post the first question on the heat pump forum.
The defrost board controls the defrost in the colder months.
Every so often the unit will go into defrost mode to remove.
Start with the basics and work your way to the problem.
Using multimeter i have determined that the nc relay on the dfc board is open.
Haven t determined yet whether the relay is bad or something in the defrost control is calling for the fan to be.