Have To Hold Down Garage Door Button To Open

Why do i have to hold down the button to close the garage door.

Have to hold down garage door button to open.

The remotes do not work the same and will not open the door at all. The amount of time it takes for the protector to reset depends on the model. Hold down on the buttons until the in car red light flashes rapidly. It closes fine but will only open if i hold the opener button down.

I have a genie intellicode. After i hold the button down to close it the sensor lights come back on. I ve made sure there are no obstacles and that the sensors are aligned properly. I have 2 craftsman 1 2 hp door openers each car has a remote and i am trying to get my remote to open with the large button on the remote and my wife s door to open with the other button.

Garage door will only open if i hold the opener button. I tried resetting them but now the large button opens both doors at the same time. Hold your transmitter up near the selected button pressing both the garage door remote and the selected in car transmitter button simultaneously. The remote control in my car will not work at all.

Wait at least 30 minutes then try the console again. When the door is up the sensor lights are off. If i lift my finger off the button before that point the door will stop and then i have to press the button again and the door will go back down. It just opens an inch and stops.

Tuesday june 26 2018 you are overriding the infrared beam sensor when you hold down the wall button continuously while the garage door is closing. This sets the in car transmitter to be your garage door openers make transmitter but you are not done. My garage door will not close unless i hold the button down. To open my garage door i have to hold down the button on my wall until the door is at least halfway up.