How to install hardie siding with a nail gun.
Hardie board siding nailing.
Fasteners shall be installed between 1 in.
I can t hold the 4x8 sheets with one hand and nail by hand with the other.
Hardie plank siding has a nail line across the top of the board that is 1 down from the top and nails are supposed to fall between and 1 from the top of the board to give the best hold.
I need a gun.
So while going for any hardie siding project it s necessary to predrill holes near the edges.
I found an old archived post that said to use a siding nailer i m only replacing 7 sheets it seems ridiculous to spend 350 on a gun to install 250 worth of siding.
James hardie prefers and recommends installation of hardieplank lap siding by the blind nailing technique such that fasteners are hidden by the course above.
If the hardiplank is being installed on a building in a humid climate or near the ocean or any large body of water the stainless steel nails are the first choice.
From the top edge and no closer than 3 8 in.
James hardie prefers and recommends installation of hardieplank lap siding by the blind nailing technique such that fasteners are hidden by the course above.
I m stuck replacing some fiber cement hardie board panel siding by myself.
Pick out stainless steel or hot dipped galvanized nails size 6d 1 1 2 inch long siding nails and 2 inch long siding nails in the quantity you need for your project.
If nail is countersunk caulk nail hole and add a nail.
Fasteners must be corrosion resistant galvanized or stainless steel.
From the ends of the plank.
Fasteners shall be installed between 1 in.
Do not over drive nail heads or drive nails at an angle.
Using a pneumatic coil siding nail gun is a much better idea than going for hand nailing.
From the ends of the plank.
Any lower and you might see a few nail heads poking through the bottom of the next board any higher and your siding is likely to be loose and.
We ve been providing a better way to build for over 100 years.
James hardie is the world leader in fiber cement siding and backerboard.
Hardie board is harder and more brittle than a normal wooden surface.